Wesley PCT-3510-6SA ST Manual de usuario descargar pdf (Pagina 23)

23 Owner’s Manual and Service Guide – PC & PCT Series

MAINTENANCE INSTRUCTIONS

Rear Axle: Check fluid level in the rear axle per the

recommended maintenance schedule. The rear axle is

provided with a fluid level check/fill plug (Figure 22) located

at the bottom of the differential. With the vehicle on level

ground, clean the area around the check/fill plug and remove

plug. The correct fluid level is just below the bottom of the

threaded hole. If fluid levels are low, add as required until it

starts to seep from the hole. Install the check/fill plug.

FIGURE 22

To replace the fluid, lift the vehicle per the lifting procedures.

Remove the rear axle cover and drain out the fluid into a

container. Clean cover mating surfaces as required with

proper scraping tool. Ensure cover lip is not bent. Apply thin

bead of RTV sealant and torque cover bolts 16-24 lb-ft.

Add 10-14 oz. 80W-90 Hypoid gear oil through the check/fill

plug hole or until fluid just starts to seep from the hole.

BRAKES

Service brakes per the recommended maintenance

schedule. The vehicle is equipped with rear drum brakes.

The parking brake is mechanically activated and the foot

brake is hydraulically actuated. Figure 23 shows the brake

connections under the vehicle.

FIGURE 23

For the hydraulic brake upgrade, the master cylinder can be

accessed by removing the floor plate on the floor board as

shown in Figure 24.

FIGURE 24

Twist the top on the master cylinder to remove the cap

(Figure 25) and check or re-fill the hydraulic brake fluid.

FIGURE 25

REGENERATIVE BRAKING

Normal braking uses the regenerative braking which is

activated by the release of the Speed Control Pedal.. (The

amount of regenerative braking or deceleration can be

adjusted within the Curtis Motor Controller. See instructions

on Page 29).

Fill Plug

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 40 41

Sin comentarios

Wesley PCT-3510-6SA ST Manual de usuario Pagina 23